The Holybro Kakute Flight Controller is a very basic but fully featured F3 based flight controller. With easy to use solder pad connections, 6050 MPU Gyro, high voltage input (Up to 6S) and a on-board regulated 5V 1A BEC while all still coming in at the standard 36x36mm layout. Some other features found on this board are the ability of soldering all necessary wires directly to the pads without use of any pin headers, a dedicated boot button for easy firmware flashing, reinforced solder pads for trouble-free direct soldering and a extremely low profile design.
Power the board directly from flight pack up to 6S on the 'BAT' pad only!
Firmware Target (Betaflight): SPRACINGF3
All solder pad hookup
6050 MPU (less susceptible to high frequency vibration)
42V input 5V 1.1A output regulator (note that up to 800ma is available external devices)
Compatible with Clean/Beta and Race Flight
8mb black box built in
STM32F303CCT6(256kB flash) 32-bit processor
High quality, gold plated PCB
Micro USB connector for programming
Dimensions: 36x36x6mm (includes USB in height)
Mounting Holes: 30.5mm square to center of holes
1x Kakute Flight Controller
1x 2.54mm Pitch pin headers
1x Quick Start Guide
My favourited go to FC. I wish it had an OSD but its still great. Awesome design and footprint and the solder pads are so freaking easy to work with.
Solid flight controller, does what it's meant to do and its very reliable. Would buy again for sure